2" to a 4" block
Thread Starter
|
New User
Joined: Aug 2005
Posts: 15
Likes: 0
2" to a 4" block
I would like to lift the rear of my truck up like an F350. I have in 2006 F250 power stroke diesel that I would like to put the 4 inch block in the rear too compensate for the sag when I am hooked up to my fifth wheel. I currently have some Timbren's installed above the rear axle, but I prefer the look of the f350 as well as the less sag that it provides. Does anyone know the part number for the 4" block as well as the longer u-bolts that I will need. Thanks in advance.
Hotshot
Joined: Dec 2003
Posts: 15,369
Likes: 121
From: Stuttgart, Ar
I'm not sure where it's posted anymore, but check the tech folders out at the beginning of this forum. It was here for a long time, or somebody may know. You can go to the dealership and ask them for the blocks and ubolts for the 350 and they should be easily found.
Lead Driver
Joined: Sep 2006
Posts: 5,665
Likes: 164
From: Cartersville, Ga
Monty0, here is the link to the thread that riggz did a write up on. Search through it and the part numbers for everything are in it somewhere. You shouldnt have to change the shocks out. I am also doing this sometime this week. Hope this helps.
https://www.ford-trucks.com/forums/6...ar-blocks.html
https://www.ford-trucks.com/forums/6...ar-blocks.html
