When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Well at work while putting the forks on the were on a pile of dirt and while gettting them in place I bent one of the small guide arms on the Power Bob-Tact. So my bad, I went to fix it, but of course a co-worker (who is a Jahovah Witness by the way) saw me, so i filled him in on my situation and he then helped me repair, kinda.
Anways with a pipe and hammer, looks and works good as new.
Today while leaving m foreman jokingly pointed this out and accidently let it slip he saw a piture of it. With some interigioating he conceeded that the co-worker who i told this to told him and provided him with a Pic.
I'm assuming on Monda the owner will get the whole 9 ards and you know what this job ainting worth it, think it's time to find a new one I've been putting up with this kinda sh%@ for too long.
I know I've said this before, and if history proves correct, I should quit, but probably won't.
Bending the Power Bob-Tach lever is no biggie and it`s easily fixed in two minutes like you did. I`ve done the same afew times.
If the pay is ok I wouldn`t quit just yet unless there are too many other hassels with this job.
Plus you get to play with some neat machinery and drive an old Louisville to boot! Out of town work does suck at times.....