I have a 2000 Ranger that starts fine. Put it into drive and no hesitation, less than 2 minutes later engine stalls while driving along. If I let it warmup 10-15 minutes no issue I can drive at any speed. OBDII first gave me a P0176 code later a P0320 code. Fuel filter has been just been changed. No ruogh idle just complete power loss. I pull over Engine starts right up only if turn key to engine off position and then turn key to restart. If I just move position of key from engine on to engine start will not start. What do you think?

 

Hi. I don't have a 2000 book. Can you tell me what the codes translate to?