'96 Ranger brake lines
Thread Starter
|
Junior User
Joined: Jun 2003
Posts: 51
Likes: 0
'96 Ranger brake lines
I am in the middle of replacing three rusted braklines, all three come out of what I am guessing is an ABS control module (has a electic motor on it). Once all three lines leave this module they go down to the frame attach with a plastic clip and from there continue on they journey, one to the left front, one to the right front and the last one goes to the rear end. I just took the 1st on off and noticed that underneath a protective plastic sleeve that part of the line is braided stainless steel. I figure this is to allow flexing betweeen the frame and the body. Should I (or even can I) buy this same type of line? I was thinking of NOT attaching the lines to the frame (where the rusted out piece of the line was) and just let ithe solid line float.
Any thoughts before I spend the rest of the afternoon/evening bending brakelines???
Thanks in advance
Royce in NH
Any thoughts before I spend the rest of the afternoon/evening bending brakelines???
Thanks in advance
Royce in NH
Thread
Thread Starter
Forum
Replies
Last Post
mlevario99
1973 - 1979 F-100 & Larger F-Series Trucks
1
Jul 27, 2007 12:02 PM
BioNate
Brakes, Steering, Suspension, Tires, & Wheels
2
Jun 24, 2007 05:00 PM
Greywolf
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
6
Dec 18, 2003 07:46 PM
