Brake question
Thread Starter
|
Senior User
Joined: Oct 2004
Posts: 420
Likes: 0
Brake question
On a 2000 F350, I putting new hardware and greasing up the sliders etc...the problem is that there was no brake pad "spreader" on there..I dont know which way the wishbone shape wire piece goes back on..it either goes with the v part up in the caliper bracket or down towards in inside of the caliper...help???
Posting Guru
Joined: Jan 2007
Posts: 2,174
Likes: 1
From: Millersburg, OR
There should be two of them on each side. Take a look at the link. They should point inward on the brake pads. One on top pointing down and the other on the bottom pointing upward....http://www.FTEs diesel forums.com/fo...ead.php?t=4870
Thread Starter
|
Senior User
Joined: Oct 2004
Posts: 420
Likes: 0
thanks, it looked like it needed two...but the boys at NAPA said only one was requirred!!
There were two in the Hardware kit..but they told me the kit was for both sides...they were wrong i guess...surprise, surprise!
There were two in the Hardware kit..but they told me the kit was for both sides...they were wrong i guess...surprise, surprise!
