parts needed for project?
Thread Starter
|
Posting Guru
Joined: Jul 2006
Posts: 1,346
Likes: 0
From: Visalia CA
parts needed for project?
so i have all the goodies ped, housing and coverplate, what gaskets if any do I need to do this. I already have ped o-rings (4), anything needed for mateing between turbo and exhaust housing, turbo and ped etc.....thanks!
Lead Driver
Joined: Oct 2004
Posts: 7,413
Likes: 1
From: Columbia, MO
Assuming you're talking about a R&R of the turbo, the 4 o-rings is all you need. There's no gasket for mating the turbo exhaust housing to the collector at the back of the engine or between the center section of the turbo and the exhaust housing.
Hotshot
Joined: Jan 2002
Posts: 17,988
Likes: 207
From: La La Land
Indebt,
If you have a set of decent calipers, would you measure both those o-ring sizes and post it here for the o-ring size collection that Alan has on the Help site? ID, OD, and thickness of the material?
Pop
If you have a set of decent calipers, would you measure both those o-ring sizes and post it here for the o-ring size collection that Alan has on the Help site? ID, OD, and thickness of the material?
Pop
