PSD bumber...installed
Thread Starter
|
Moderator
Joined: Jun 2003
Posts: 3,549
Likes: 71
From: Calhoun GA
PSD bumber...installed
I got my Powerstroke (PSD) bumper and front valance/airdam back from the body shop and installed them. This gives the PSD interooler and PSD trans cooler, that I also have installed, a little more air.
Super Moderator
Joined: May 2004
Posts: 29,380
Likes: 118
From: Central Coast of CA
I'd like to see that lower lip extend a tad further in the corners (wider look), giving the front end a more squared off look, as opposed to the way its a little narrower at the bottom, but all in all, I like it!
Matt, can you post up a picture looking straight on, from a standing point of view and one from down low?
Stewart
Matt, can you post up a picture looking straight on, from a standing point of view and one from down low?
Stewart
Thread Starter
|
Moderator
Joined: Jun 2003
Posts: 3,549
Likes: 71
From: Calhoun GA
Originally Posted by S_Harvey
...Matt, can you post up a picture looking straight on, from a standing point of view and one from down low?
Stewart
Stewart
Thread
Thread Starter
Forum
Replies
Last Post
