E4OD replacement pans
Thread Starter
|
Junior User
Joined: Jan 2007
Posts: 57
Likes: 0
E4OD replacement pans
Can anyone recommend a good replacement pan for the e4od? Has anybody swapped pans for a different one and do you like it? Preferably something that is built tough with extra capacity.Thanks.
Elder User
Joined: Mar 2006
Posts: 627
Likes: 0
I have never used one and don't know anyone who has but I see Baumann offers a deep aluminum pan. Look about 3/4ths of the way down on this page:
http://www.becontrols.com/products/e4odcat.htm
http://www.becontrols.com/products/e4odcat.htm
Thread Starter
|
Junior User
Joined: Jan 2007
Posts: 57
Likes: 0
Thanks! Thats funny you suggested Baumann. The reason I am looking for a different pan is because I just received my TCS from them and if I have to change solenoids in the tranny-then I have to remove the pan-so I might as well put a deeper one on.
Thread Starter
|
Junior User
Joined: Jan 2007
Posts: 57
Likes: 0
I had to phone them to get a response, but when I got a hold of them they were very helpful. I dealt with Greg Dantzler really good guy.Yes that is a good idea. I am starting the install in about ten minutes so I will do that.
