Wiring help / questions?

Reply Subscribe

Thread Tools

Search this Thread

Jan 15, 2007 | 03:06 PM

250HUV

Thread Starter

Freshman User

Joined: Dec 2006

Posts: 34

Likes: 0

Wiring help / questions?

Hey all, need some help. I have a 07 250 PSD 4x4 fX4 CC LB I'm looking at putting the heated seates in from http://www.heatedseatkit.com. The switch location I was looking at was on the power point knock out. When I opened it I found a wiring harness that dead ended into the back of the knock out. Is this the harness for the airbag deactivation switch? If so is it just a matter of installing a new knock out with the power pt. and the switch? Is there any more to it. The harness had the following wires: wht / blu, blk / orange, orange / yellow, yellow / grn. finding the above made me curious. On the 4x4 switch I found two harnesses that dead ended into the back of the knock out. One has a green 8 pin clip with the following wires: blu/red, blk,grn/purp, purp/brn,pink/orange this was on the right side. On the left side was black clip with the following wires: 3 blacks, purp/grn, blu/blk, purp/blu, blu/red. I have no idea what these are for. I feel like I'm missing out on a mod. Any help would be appreciated.

Thanks,

250HUV

Jan 15, 2007 | 03:20 PM

Beerstalker

Postmaster

Joined: Jan 2005

Posts: 4,743

Likes: 3

From: Peoria, IL

I won't guarantee this but I would venture to guess that the one by the power point is the airbag shutoff, and the two by the ESOF are for the reverse sensors and power rear sliding window.