Tip Question
Thread Starter
|
Freshman User
Joined: Sep 2006
Posts: 44
Likes: 0
Tip Question
I was looking to replace the old, rusted tips on my dual exhaust with some new polished ones. The problem is finding other 18" long tips witht he right inlet.
I found some nice tips, made by Hedman, but they are 2.5" inlet. I need 2.25" inlet. Is there any way to match up the two when welding the new tips on, or am I out of luck?
I found some nice tips, made by Hedman, but they are 2.5" inlet. I need 2.25" inlet. Is there any way to match up the two when welding the new tips on, or am I out of luck?
