Homelink Mirror Installation
Thread Starter
|
FTE Leadership Emeritus
Joined: Aug 2006
Posts: 47,280
Likes: 172
From: DELAWARE, The First State
Homelink Mirror Installation
I am installing a Gentex auto dim mirror with Homelink.
I need to find two wires, 1. 12+v switched by ignition and 2. 12+v constant power.
This mirror is being installed on a 2005 F250 SD. I have already installed the wiring harness thru the drivers side A pillar and down to near the fuse panel.
Any help would be appreciated.
I need to find two wires, 1. 12+v switched by ignition and 2. 12+v constant power.
This mirror is being installed on a 2005 F250 SD. I have already installed the wiring harness thru the drivers side A pillar and down to near the fuse panel.
Any help would be appreciated.
Post Fiend
Joined: May 2006
Posts: 10,007
Likes: 4
From: Central Florida
12volts yellow (30A), lt grn/pur (30A) + ignition harness
Starter dk. green + ignition harness
Second Starter N/A
Ignition red/lt. green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory gray/yellow and red/black + ignition harness
Second Accessory dk. blue/lt. green + ignition harness
Keysense black/pink - ignition harness
Starter dk. green + ignition harness
Second Starter N/A
Ignition red/lt. green + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory gray/yellow and red/black + ignition harness
Second Accessory dk. blue/lt. green + ignition harness
Keysense black/pink - ignition harness
Thread
Thread Starter
Forum
Replies
Last Post
