HELP!! New distributor issues.

Reply Subscribe

Thread Tools

Search this Thread

Sep 29, 2006 | 08:19 PM

#16

5_labsownus

FTE Chapter Leader

Joined: May 2002

Posts: 42,686

Likes: 3,152

From: Fraziers Bottom, WV

As I remember the deep notch is 0*. I will look at my truck over the weekend and see!

Sep 30, 2006 | 07:10 AM

#17

Steamir

Senior User

Joined: Aug 2005

Posts: 154

Likes: 0

From: Hampton, Va

You need to use the scribed line on your balancer, not the notch. No idea why the notch is there, but the line is the correct one to use.

Sep 30, 2006 | 07:34 AM

#18

headcustodian

Junior User

Joined: Jul 2006

Posts: 61

Likes: 0

Thanks on that. I am pretty sure the other mark is for magnet strobe. I would just like to know where 10*btc is on that scale as I cannot get close enough to see it. If I can line up on that mark. I can remark on the other side where I can see more clearly.
thanks

Sep 30, 2006 | 10:34 AM

#19

headcustodian

Junior User

Joined: Jul 2006

Posts: 61

Likes: 0

Ok moved a few things out of the way and was able to clean the scale. The deep V groove is 10*btc. Still very difficult to see mark when engine is running. Soooo I lined it up by hand and simply marked the other side where i have full view.
Thanks for all the help. Atleast I know Im dead on now. Couldn't have done it without everyones help.
Thanks again
Frank

Reply Subscribe

Reply Share

First
Prev
2 / 2
Next
Last

Forum Jump