Rear end swap
Thread Starter
|
New User
Joined: Jul 2006
Posts: 5
Likes: 0
Rear end swap
Hey guys I am a little new to the truck scene can anyone tell me if a 10.25 or a dana 60 from a F250 (1987) dana or 1994 (10.25) will bolt in to my 1984 F150 without any changes other than drive shaft. My 8.8 finally died and I have both of these in my driveway and are junk anyway as I have been putting there parts on the 150 for years. Thanks
Lead Driver
Joined: Dec 2002
Posts: 5,495
Likes: 17
From: Kuna ID
I would measure the spring pad width, and the distance between the spring pads on your donor trucks and compare to the 8.8 on your F-150. Someone else might know for sure, but thats where I would start.
Thread
Thread Starter
Forum
Replies
Last Post
TURBO
Clutch, Transmission, Differential, Axle & Transfer Case
8
Sep 29, 2016 12:44 AM
ColdForge
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
5
Aug 12, 2011 06:26 PM
matt_1
1973 - 1979 F-100 & Larger F-Series Trucks
1
Aug 15, 1999 08:49 PM
Matt
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
1
Aug 15, 1999 02:10 PM
