carb ports
Thread Starter
|
Junior User
Joined: Aug 2006
Posts: 92
Likes: 0
carb ports
Hi gang. I'm new to this forum and have a question about the carb that is on my 85 full size bronco. Here is the low down on what I have. It has a 300 inline 6 engine, headers, offenhauser intake, Holley ( I was told its a 4160) 4 barrel, all the polution stuf was taken off before i acuired it. I'm trying to restore all of the polution stuff. My question for now is: Where do these 2 ports get hooked to from the carb. One port is open,no hoses to it. it is on the side towards the top to the left, where does this go? The second port in question is capped and is located at bottom right of carb, where does this port go? I'm attaching a pic of the carb, it isn't a real good pic but if you look real close you can see the capped port. Well sorry for no pic, I cant figure out how to include a pic in this post.
Any help would be greatly appreciated.
Thanks, Bill
Any help would be greatly appreciated.
Thanks, Bill
Lead Driver
Joined: Sep 2002
Posts: 9,182
Likes: 12
From: Gateway to the West
Create a gallery and link back to the photos in the gallery.
As for the emissions setup on the 300, you might also pose the question in that forum. There may be specific things the guys with 300's here can answer about the setup in the Bronco as well.
As for the emissions setup on the 300, you might also pose the question in that forum. There may be specific things the guys with 300's here can answer about the setup in the Bronco as well.
