'02 Screw setup
Thread Starter
|
New User
Joined: Jul 2003
Posts: 6
Likes: 0
From: Florida
'02 Screw setup
Ok, I know that this has been asked a hundred times before. I have been reading and searching the forums for a couple of weeks now and the more I read the more confused I get.
Anyway, I am looking to do some mods on my truck here in the very near future and I definitely want to put an exhaust on my truck. Right now, everything is stock. I want to increase performance a bit and give my truck a nice low rumble. I am not planning on racing it and I don't want to wake up the neighbors when I leave for work at 5 am. So here is what I am looking at doing right now:
K&N Intake model 57-2541
Flowmaster exhaust model 17222
Hypertech Power programmer III
I am looking to keep my cost around $1000-$1250. Any thoughts, pros/cons, better suggestions? Also maybe some suggestions on where to get the best prices? Thanks for the help,
Kevin
Anyway, I am looking to do some mods on my truck here in the very near future and I definitely want to put an exhaust on my truck. Right now, everything is stock. I want to increase performance a bit and give my truck a nice low rumble. I am not planning on racing it and I don't want to wake up the neighbors when I leave for work at 5 am. So here is what I am looking at doing right now:
K&N Intake model 57-2541
Flowmaster exhaust model 17222
Hypertech Power programmer III
I am looking to keep my cost around $1000-$1250. Any thoughts, pros/cons, better suggestions? Also maybe some suggestions on where to get the best prices? Thanks for the help,
Kevin
