setting clock spring
Thread Starter
|
Junior User
Joined: Jul 2004
Posts: 95
Likes: 0
setting clock spring
I am replacing a tilt column in my 96 F-150. I had to have a lock smith drill out the ignition lock because the place where i bought the column lost the keys. The lock smith told me to make sure i reset the clock spring before i install it. I searched for about an hour and found lots of threads on clock springs but none on setting it. Can anyone give me a quick how too on setting the clock spring. Thanks in advance for any help.
Post Fiend
Joined: May 2004
Posts: 11,289
Likes: 6
From: Lakewood, Ohio
it is like 50 pages long and it only shows how circuit works.
i have never had mine apart.
was he talking about reseting the lock?
if you replaced lock cylinder why do you have to worry about clockspring?
edit: on the very last page it refered my to adjusting sliding contact.
i do not feel like typing it in and it includes a drawing. i will photograph it and email it to you sometime late this afternoon.
i have never had mine apart.
was he talking about reseting the lock?
if you replaced lock cylinder why do you have to worry about clockspring?
edit: on the very last page it refered my to adjusting sliding contact.
i do not feel like typing it in and it includes a drawing. i will photograph it and email it to you sometime late this afternoon.
Last edited by quicklook2; Jun 1, 2006 at 02:24 PM.
