Removing rivots?
Senior User
Joined: Apr 2002
Posts: 414
Likes: 0
From: Austin, TX
Originally Posted by 51dueller
I like to cut 2 slots in the head of the rivit and then hit it with a hammer and chisel. It takes about 3 hits and it leaves a nice clean face, then hit it with a punch.
Tim
Roast em' if you got 'em
Joined: Mar 2005
Posts: 21,970
Likes: 9,782
From: Rio Rancho, NM
Originally Posted by imlowr2
Bobby- I took your advice on putting my hands on the grinder. Unfortunately, that advice didn't make much difference in getting the rivots out. So, being the intelligent person I am, I decided to use the air chisel and see just how much force it takes by using my index fingers on both hands and chiseling to the point where I was able to visually see my bone. As a result, both of my hands are now bandaged to the point I can only hold onto my power drill using my elbows and chin area. I think I'll go with drilling a 1/8" hole and progressing to a 3/8" hole to get the rivet out. But I must admit, you have provided me with some sound advice!!!! Thanks Bobby.
BTW- I like the idea of grinding the head down for the center punch. Ed
BTW- I like the idea of grinding the head down for the center punch. Ed
Just kidding
Hope it all works out
Bobby
