coil spacers
Thread Starter
|
New User
Joined: Jan 2006
Posts: 11
Likes: 0
coil spacers
hey everyone, new here to the forum and rangers, just recently got a 93 4x4 3.0 so i have a few questions. first , today i was given 2 feet of polyurathane. my ranger is alot lower in the front than in the rear so i was going to make some coil spacers to bring the front up a bit. dosnt look to hard but i wana be able to go as high as possible with these in a safe way and from what ive seen the biggest coil spacer i can find is 3" which would be perferct. but will this be ok? or will i have to go with a 2" ?
Post Fiend
Joined: Jan 2005
Posts: 7,147
Likes: 0
2 inch sounds right, 3 inch may have you running uphill a tad. I cranked my torsion bars 1.5 inches, and it's close to level. Because of the age of your truck, 3" may work because of sag. You may need to experiment alittle, since you have 2 feet of it.
