New guy
Thread Starter
|
New User
Joined: Feb 2006
Posts: 7
Likes: 0
New guy
Hello to everyone! Nice to see so many fte's. I'm from the KC area. I have a couple of trucks. I picked up my new 05 screw last friday. It goes in for liner, 6 in fabtech and 35 BFG MT Monday. Ordered nurf bars and Hypertech for it as well. Should be in tomorrow. I think it will be pretty tight when I get it back. I also have an 1955 F100 My dad and I built when I was in highschool. It is on a 76 4x4 frame with 33's. All ford parts! No chevy!!! It's purple with ghost flames. I'm getting ready to tear it apart and redo body, lift, and slap on 35's.
Last edited by cheapscrew; Feb 16, 2006 at 09:39 PM. Reason: in wrong forum
FTE Leadership Emeritus
Joined: Jan 2003
Posts: 161,999
Likes: 75
From: 3rd Rock
...Welcome to Ford Truck Enthusiasts!
If you get a minute check out the link here, it will help you to navigate around and understand this site.
https://www.ford-trucks.com/forums/s...88#post3272088
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
If you get a minute check out the link here, it will help you to navigate around and understand this site.
https://www.ford-trucks.com/forums/s...88#post3272088
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
Thread
Thread Starter
Forum
Replies
Last Post
