Generator Light
Thread Starter
|
More Turbo
Joined: Jun 2003
Posts: 687
Likes: 80
Generator Light
I installed a GM three wire, internally regulated alternator in my '56 with 292. It works great. The funny part that I can't work out is that on initial start up, the generator light will stay on until rpms reach about 2,200 to 2,500 rpms at which point it will go off and stay off unless the rpms drop below 400 rpms or so. It really isn't a problem as I can make it go off by revving the engine once in the morning, but I am wondering about what is going on here. I don't think the alternator is at fault- is it the lamp itself?
Steve
Steve
Moderator
Joined: Jan 2001
Posts: 56,984
Likes: 2,738
From: Virginia
Let's double check your wiring.
You have the large output wire going to the bat +.
You have the red #2 small wire jumped to the bat output lug in the alt.
You have the other small wire on #1 terminal running to a ungrounded bulb and socket, with the other wire leaving the socket going to the key on power of the keyswitch.
You have the large output wire going to the bat +.
You have the red #2 small wire jumped to the bat output lug in the alt.
You have the other small wire on #1 terminal running to a ungrounded bulb and socket, with the other wire leaving the socket going to the key on power of the keyswitch.
Senior User
Joined: Oct 2005
Posts: 174
Likes: 0
From: brooks a.b.
one thing to check is the bulb in the dash. it may be that the bulb is to small(it is not letting enough voltage or amperage go to the alt to magnetize the regulator). i have seen this before on trucks that have been converted in the way you have done and when you rev the engine the rpm of the rotor causes enough magnetizem to turn the reg. on(like a one wire alt).
Thread
Thread Starter
Forum
Replies
Last Post
jvmcc
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
Sep 27, 2016 11:19 AM
madMatador78
1994.5 - 1997 7.3L Power Stroke Diesel
18
Apr 18, 2015 07:32 AM
YellowXLT
Escape & Escape Hybrid
5
May 26, 2014 12:04 AM
