New User
Thread Starter
|
1st Gear
Joined: Oct 2005
Posts: 1
Likes: 0
New User
Hello,
I am new to this site. I have a '98 Ranger with a 3.0L that is on the engine stand ready to go back in. It stuck the #5 exhaust valve so I decided to rebuild it (rings, bearings, timing chain etc.). I also have a 2000 Excursion and 3 big block B-Body Mopars. Regards.
I am new to this site. I have a '98 Ranger with a 3.0L that is on the engine stand ready to go back in. It stuck the #5 exhaust valve so I decided to rebuild it (rings, bearings, timing chain etc.). I also have a 2000 Excursion and 3 big block B-Body Mopars. Regards.
FTE Leadership Emeritus
Joined: Jan 2003
Posts: 161,999
Likes: 75
From: 3rd Rock
...Welcome to Ford Truck Enthusiasts!
If you get a minute check out the link here, it will help you to navigate around and understand this site.
https://www.ford-trucks.com/forums/s...88#post3272088
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
If you get a minute check out the link here, it will help you to navigate around and understand this site.
https://www.ford-trucks.com/forums/s...88#post3272088
We are happy you have chosen the best source for Fords!
Enjoy FTE and The State Chapters are located at the bottom of the main forum page.
JOIN CLUB FTE -SUPPORT THE FORUMS!
See you on the boards.
….
Thread
Thread Starter
Forum
Replies
Last Post
