Question about O rings
Thread Starter
|
Junior User
Joined: Oct 2003
Posts: 58
Likes: 0
From: oh
Question about O rings
Can anyone out there tell me what size those "O" rings are for that fuel bowel drain valve? And also,has anyone ever bought the hole thing from ford or International? Is it me ? Unless you want a chip or 4'"exhaust,you aint findin repair parts on this board..
Senior User
Joined: Jun 2003
Posts: 452
Likes: 0
From: SC
Originally Posted by tcervi1028
Can anyone out there tell me what size those "O" rings are for that fuel bowel drain valve? And also,has anyone ever bought the hole thing from ford or International? Is it me ? Unless you want a chip or 4'"exhaust,you aint findin repair parts on this board..
What is wrong with any of these?
http://www.blackclouddiesel.com/Ford/codepigtails.htm
You may want to take a little time and search some of the sponsors of this site for yourself next time. That long list to the left of this page.
Hotshot
Joined: Jan 2002
Posts: 17,988
Likes: 207
From: La La Land
They are 1/2" OD, 1/4" ID, 1/8" material.
I used two Danco #90 from Home Depot, but Danco says they're not "diesel-rated" material.
That was over a year ago. So far, so good. Next time I replace them, I'll use rings of a "rated" material, but I'm not changing them just for the heck of it.
Pop
I used two Danco #90 from Home Depot, but Danco says they're not "diesel-rated" material.
That was over a year ago. So far, so good. Next time I replace them, I'll use rings of a "rated" material, but I'm not changing them just for the heck of it.
Pop
