Has anybody but the whole Edlebrock package on there truck? heads, intake and cam.I am think of going that route with my F350.I already have a new 3 inch cat and Flowmaster cat back , FMS shorties 1 5/8 and FMS/K&N air charger kit.I use my truck for dump , home depot runs and pulling a car trailer.Does anyone have any before and after dyno runs?.

The reason I am asking is because I need a set of heads for the truck.I have three broken plugs and two studs in one and three broken studs in the other(the studs are flush so they have to come off).If the truck will run good with this combo now I will go ahead and do it.If not I will look for a cheap set of stock heads and do it in the spring.And go ahead with the MA conversion now.

Thanks
Mike