Hub Question!
Thread Starter
|
New User
Joined: Oct 2005
Posts: 1
Likes: 0
Hub Question!
I have a 1995 f150 .302 Manual trans Dana 44 front axle. I changed out the three hole cap factory aout locking hubs with warn premiums. I had two hubs break. After the last one somebody I told about it asked if I put the three thrust washers and the c clip back in it. I had not. I put those back in and now the nubs don't fit into the housing. Should these be there or not. the directions for the warn hubs say the remove all retaining clips. which I took to mean the thrust washers also. But now that I look at the diagram at the top it shows the three thrust washers and the c clip witha note that says 95-96 Ford trucks only. I am at a loss as to what to do. Please help!!! I miss driving my truck!!!
FTE Leadership Emeritus
Joined: Jan 2003
Posts: 161,999
Likes: 75
From: 3rd Rock
...Welcome to Ford Truck Enthusiasts!
Stick around someone will be by shortly to answer your question.
We are happy you have chosen the best source for Fords!
Enjoy FTE....and
JOIN CLUB FTE -SUPPORT THE FORUMS!
…..See you on the boards.
Stick around someone will be by shortly to answer your question.
We are happy you have chosen the best source for Fords!
Enjoy FTE....and
JOIN CLUB FTE -SUPPORT THE FORUMS!
…..See you on the boards.
Fleet Mechanic
Joined: Nov 2003
Posts: 1,372
Likes: 14
From: West Cornwall, CT
Check out the Warn website (warn.com). From the information there, you need to remove the c-clip, thrust washers and bearing locknut assembly and install a conversion kit. The kit is a pair of wheel bearing locknuts. Install the kit and then the hubs should work fine.
Lou Braun
Lou Braun
