headlamp assembly
Thread Starter
|
New User
Joined: Sep 2005
Posts: 1
Likes: 0
headlamp assembly
Hey I need some info on removing a headlamp that busted on the inside. I am trying not to bust up the headlight anymore than it already is but what can I say. I am a brook college kid. I want to save the headlight so I can reuse it. Right now it is pointing up and blinding everyone that drives in front of me. I guess you could say that I m jery riggin it. If anyone has any ideas or info, please let me know. Thanks
Last edited by Ken00; Sep 17, 2005 at 08:03 PM.
cheep
Freshman User
Joined: Jun 2005
Posts: 37
Likes: 0
From: Vandenberg AFB CA
I'm trying to replace the headlamp as well. My 94 Bronco had the left bulb burn out sometime prior to my purchase and they rigged up the new bulb with silcon. That explains why I couldn't adjust my "lazy eye" and kept blinding oncoming traffic. I have the Ford Service Manual, but it's drawing and directions are not good.
The two screws on top of the headlamp door are obvious, but then it describes two nuts that also retain the door. The drawing breaks down where the nuts are in the rear and at the bottom, but I can't find em.
Anyone deal with a busted lamp and have to swap? I'm about to rip out the plastic door!!!!
The two screws on top of the headlamp door are obvious, but then it describes two nuts that also retain the door. The drawing breaks down where the nuts are in the rear and at the bottom, but I can't find em.
Anyone deal with a busted lamp and have to swap? I'm about to rip out the plastic door!!!!
