I ran my PSD on the 1/4mi
#1
I ran my PSD on the 1/4mi
A friend of mine had a 01 Dodge CTD, he recently put in and edge chip(not usre which one) air filter, MBRP exhaust, air filter, and a few other mods. He was heading up to the track to finish dialing in the truck after the new trans so I went up to see how mine would run, as I plan on modding my truck a bit.
Pretty much stock I ran a 17.56 was my best time out of 3 runs. I figure thats not too bad figuring that its rolling on 35s. The only mod that I have to the engine is a Walker BTM. Mods planned for the spring should get me some times closer to my buddy's 14.4 in the CTD. I am looking the Edge with attitude system, MBRP exhaust. Im not sure what Ill do about the air filter. Sugestions?
What do you think of the times?
Tom
Pretty much stock I ran a 17.56 was my best time out of 3 runs. I figure thats not too bad figuring that its rolling on 35s. The only mod that I have to the engine is a Walker BTM. Mods planned for the spring should get me some times closer to my buddy's 14.4 in the CTD. I am looking the Edge with attitude system, MBRP exhaust. Im not sure what Ill do about the air filter. Sugestions?
What do you think of the times?
Tom
#2
Air intake, take a look at this! Many including myself like it, there are a few who don't, read on and make our own decision.
https://www.ford-trucks.com/forums/s...d.php?t=277571
https://www.ford-trucks.com/forums/s...d.php?t=277571
#3