Removing spray mist
Thread Starter
|
More Turbo
Joined: Aug 2004
Posts: 577
Likes: 15
From: Georgia
Removing spray mist
I recently lifted my 2002 F350 PSD CC SB SRW 4x4. You could see that the rear inner fenderwells had not been painted very well from the factory. Lots of white and black splotches so yesterday I covered the area around the fenderwell and painted the inside with Rust-Oleum Professional High Performance Enamel in black. Today some 20 hours later I go out and find some spray mist had gotten on the area past my covered part. The paint's instructions say to use Xylol to clean wet or dry paint and mineral spirits to clean wet paint. I have never used Xylol before. Can this be used without messing up the original paint (Oxford White clearcoat)? Using a small amount of rubbing compound may work but still what about the original paint and clearcoat?
Any suggestions?
Any suggestions?
