Opinions On Stacks
Thread Starter
|
New User
Joined: Jun 2005
Posts: 8
Likes: 0
Opinions On Stacks
Anyone know the cheapest way to get stacks? I know a couple sites that sell them but their expensive..I want at least 5" Chrome tip-out stacks for my 2002 f250 powerstroke...Can someone please help me!!!!
Posting Guru
Joined: May 2004
Posts: 1,358
Likes: 3
From: China Grove, TX
i second ruber duck. i got my 26'' mitre cuts from a truck boneyard, so they were a little beat up, but hey, can't beat 30$$ right?? berubes is a good place, and if you have any big-rig stores near where you live, check in there too before you go ordering everything. goo dluck, just ask us if ya got any questions
Posting Guru
Joined: Feb 2004
Posts: 2,248
Likes: 1
From: Elverson, PA
My answer is the same as Rubberduck - I got my stacks on E-Bay - and got parts from Berube's and airflow.com - as each had some of the parts cheaper than the other! I spent a little under $600 for ALL the stuff I needed, and spent about 5 hours in my shop doing the fabrication and putting them on my truck. You could do it cheaper, but I wanted my pipes in the bed to look good too, so I went with all piping. I have seen guys that have a square or rectanglular tube across the bottom of the bed with the stacks attached to that... but IMO that looks kinda cheezy - but cheaper than all the bends and Y pipe.
Posting Guru
Joined: May 2004
Posts: 1,358
Likes: 3
From: China Grove, TX
thats got a good drwaing of the parts needed if anyhting. jsut scope it out. looks jsut like the way i set mine up. only hting is i find it hard to believe that chrome is 36'' long....looks more like 24....but then again, it is on a goat
