Clutch question HELP PLEASE
Thread Starter
|
New User
Joined: May 2005
Posts: 13
Likes: 0
Clutch question HELP PLEASE
On my '88 F-350 my clutch went out and i went and bought a clutch kit that came with the slve cylinder. But the slave cylinder that came with the kit is one that is on the inside of the bell housing but the one on the truck is on the out side of the transmission? did this year of truck have two different locations for the slave cylinder? and the engine size is a 460 (7.7L) any help would be greatly appreicated.
Laughing Gas
Joined: Jul 1999
Posts: 1,048
Likes: 22
From: Lacey, WA
Hi,
I would go back to the parts house that you picked up the kit from and have them look it up again. This is TOO common a mistake.
Take the old slave cylinder with you for comparison.
Good luck,
Lee
I would go back to the parts house that you picked up the kit from and have them look it up again. This is TOO common a mistake.
Take the old slave cylinder with you for comparison.
Good luck,
Lee
Cargo Master
Joined: Oct 2004
Posts: 2,148
Likes: 0
From: Seneca, SC
yeah the parts place just looks up the first/ cheapest option and gives you that. I have to get on them for the clutch/flywheel on my truck because my truck is a 77 with the I6 and there's a split in the clutch/flywheel mid-year for that model. that's not your problem, but you have to stay on those guys to get you the right part. There's normally one guy on each shift that actually knows what you're talking about. If you can get to him you're golden.
