302 Stroker Motor
Thread Starter
|
Freshman User
Joined: Feb 2000
Posts: 40
Likes: 1
302 Stroker Motor
I see Ford makes a 302 Stroker (347 c.i.d). I'd like to replace the 302 in my '89 F-150 and with this motor and was wondering if anybody has done this. My question would be: Would the computer complain about the extra displacement? And if so, what mods would I have to make. Also, would there be any other modifications that I would have to make installation wise?
Thanks in advance.
Thanks in advance.
Elder User
Joined: Jan 2000
Posts: 966
Likes: 2
From: Crooked River Ranch, OR
302 Stroker Motor
You'll need to change over to the "Mass Air Sensor" conversion kit from Ford. For a manual trans use part # M-9000-T50 for the AOD auto trans use part # M-9000-T51. Either kit will set you back around $700. If you try running the stroker motor without replacing your EFI system the motor will run too lean. Deen
Posting Guru
Joined: Jun 1999
Posts: 1,100
Likes: 0
From: Durham
302 Stroker Motor
I've read several posts over the past few weeks that warn against putting a stroked 302 into your vehicle. The suggestion was to go for a 302 that is stroked less or dump a 351W in instead of the 347. I'll try to find some of the posts on other forums and post them here.
'82 F150 2WD w/351W (orig 300 I6)
Slik
'82 F150 2WD w/351W (orig 300 I6)
Slik
