Engine Build
Thread Starter
|
Senior User
Joined: Feb 2004
Posts: 184
Likes: 0
From: Va Beach
Engine Build
I have a 93 Bronco with the 351. I've been planning on rebuilding or replacing the engine for some time now. I'm thinking a stock short block(either rebiuld the one I have on just get one) gt40 iron heads, Edelbrock EFI intake, BBK 56mm TB, roller cam and 1.7 rockers. What cam do you guys think would run well for this. This is my daily driver but would like more bottom end for towing. I'd like to keep it speed density if at all possible, would I need to get a chip burned for this. Anything else I would need?
Elder User
Joined: Dec 2003
Posts: 655
Likes: 0
From: Miami
There are alotta plug 'N' play stuff for them. Tweezer I think is one of them. Just be careful on cam selection. Ford racing has a mass air kit for speed density trucks. It is more effeicent and accepts changes. Just a thought.
Al
Al
