Front Marker Light Bulb Replacement
Thread Starter
|
Senior User
Joined: Nov 2003
Posts: 118
Likes: 1
Front Marker Light Bulb Replacement
I have a 1993 F250 4wd and I am trying to figure out how to replace the front marker light bulb (194na). It is the one that is on the side on top. Anybody have an idea how to get to the bulb? Does the reflector housing come off the truck? If so, how? I removed the 2 screws on top and was able to pull the plastic frame around the housing a little bit forward, but that was it.
Thanks in advance,
Blane
Thanks in advance,
Blane
Senior User
Joined: Feb 2004
Posts: 155
Likes: 0
From: Alaska
That is what needs to happen, but there are two nuts that are hiddedn down at the bottom. They are 10mm, if you remove these the assembly should come right out and allow you acces to all the bulbs. The nuts are on the front portion of the headlight bezel, inside the engine compartment. I beleive they each have a little opening that you need to put a socket thru. I think I used a deep 10mm on a quarter inch ratchet.Good Luck
Senior User
Joined: Dec 2001
Posts: 331
Likes: 0
From: Michigan
92supercab is correct about the two nuts hidden down below. You have to remove the two screws on top plus the two nuts (i thought they were 11MM but i might be wrong. sometimes when you remove the one closest to the radiator the nut will not come off but will unscrew from the turn signal housing.
I talked about this awhile back in the electrical forum.
I talked about this awhile back in the electrical forum.
Thread
Thread Starter
Forum
Replies
Last Post
blanes
1987 - 1996 F150 & Larger F-Series Trucks
8
Nov 25, 2013 02:45 PM
Midwest Dually
6.4L Power Stroke Diesel
3
Nov 9, 2013 01:28 PM
blanes
1987 - 1996 F150 & Larger F-Series Trucks
14
Mar 2, 2012 12:16 PM
Turx
1987 - 1996 F150 & Larger F-Series Trucks
2
Feb 17, 2011 07:12 PM
