Desktop dyno run please
Thread Starter
|
Mountain Pass
Joined: Jul 2004
Posts: 183
Likes: 4
From: Indiana
Desktop dyno run please
Can someone run my planned motor build through a dyno program to give me an idea of where the HP and torque will be please.
The motor is a 460 bored .030
Flat top pistons, compression ratio will be 10:1
D3 heads ported and polished 3 angle valve job
Edelbrock Performer RPM intake port matched
headers are L&L - 1-3/4" tubes
Stock stroke
For the carb, please run a Holley 850 Double pumper, Holley 750 dp and a Barry grant 850.
Cam will be a Crane solid .238/.248 @.050, .547/.570 lift, 112 deg. seperation
Will have a C6 tranny.
Thanks
The motor is a 460 bored .030
Flat top pistons, compression ratio will be 10:1
D3 heads ported and polished 3 angle valve job
Edelbrock Performer RPM intake port matched
headers are L&L - 1-3/4" tubes
Stock stroke
For the carb, please run a Holley 850 Double pumper, Holley 750 dp and a Barry grant 850.
Cam will be a Crane solid .238/.248 @.050, .547/.570 lift, 112 deg. seperation
Will have a C6 tranny.
Thanks
