dana 50 IFS
Thread Starter
|
Elder User
Joined: Nov 2003
Posts: 752
Likes: 0
From: Kalispell, MT
dana 50 IFS
has anybody done, or know what parts need swapped to turn a 1/2 ton IFS into a 3/4 ton IFS??? from what i've found so far, apparently the only parts that need swapped are the spindle, bearings, brake rotors, calipers and pads, and maybe the hub housing....and the springs...am i correct in this theory???
MontanaFord
MontanaFord
Thread Starter
|
Elder User
Joined: Nov 2003
Posts: 752
Likes: 0
From: Kalispell, MT
thanks for the help...i'll hafta check on it...what about swapping wheel spindles between a 44 and 44HD? would they be the same size? or?? and from there, if the spindles could be swapped out from a 1/2 ton to 3/4, then just the rotor, brakes and bearings would be all that would really need swapped, i assume....is this correct, or am i off base on this?? just curious...
MontanaFord
MontanaFord
