Big Wiring Mess
Thread Starter
|
New User
Joined: Dec 2004
Posts: 2
Likes: 0
Big Wiring Mess
I have a big problem with my 87 f 250, my tail light fuse keeps blowing everytime i activate it. I have both high and low beams, working correctly including select light on dash, I have brake lights and all turn signals all working correctly including on dash. I tried replacing the switch, no help. i disconnected the rear light harness and still blowing fuses so its not in the tail lights, yes all lights are in working conditions both filiments. I have all the dash indicator lights check engine, 4x4, turns, but no dash lights themselves fuel, oil,temp, etc. Also the radio lights dont work nor do the cigarette lighter lights or the glove box. when i plug a new fuse in and turn it on for a second before it blows the washer indicator light starts to light up but dies with the fuse. I cannot figure out why this light is affected because it is on fuse #10 and the tails are on #4.Also i am pretty sure i had tail lights not that long ago i dont know what could have happened. Please help i need a vehicle. any help would be appreciated.
FTE Leadership Emeritus
Joined: Jan 2003
Posts: 161,999
Likes: 75
From: 3rd Rock
WELCOME to the site, please read the Guidelines… Check out the list of forums and make sure you read the headings and Read First: notices in each forum. The members in this forum are very knowledgeable about these trucks, they will be by..... and help you with your question. 
Good luck with your problems.
Enjoy FTE
Good luck with your problems.
Enjoy FTE
Moderator
Joined: Jan 2001
Posts: 57,025
Likes: 2,758
From: Virginia
i disconnected the rear light harness and still blowing fuses so its not in the tail lights
