wiring woes
Thread Starter
|
New User
Joined: May 2003
Posts: 18
Likes: 0
wiring woes
I had a blow out on the road and to make a long story short the tire chewed up the left inner fender well and the wires that sit on top on it . I called a dealer and they said they don’t make the engine wiring harnesses any more no luck at finding one at the local bone yard as they just cut them .I looked on Ebay and saw one for a 4.9 liter with the pcm .I think mine is dead the pcm I mean . I also saw ones for a 4.6 mustang .Does any one know if I could make these work some how most of the damage is right before the fuse box that sits on the wheel well . I tried to match all the wires together and I replaced all the blown fuses it just cranks over and beeps 55 when the key is on . I can smell gas so it must be a bad wire . all I want is the thing to start and go. The truck is a 94 Ford F150 2wd auto
Any thoughts would be Helpfull
Any thoughts would be Helpfull
Lead Driver
Joined: Nov 2002
Posts: 9,557
Likes: 44
From: Concord, NC
You will need pretty much the entire under hood harness from an F150, likely with the 4.9, but the underhood harness might be the same between engines, I do not know. It is possible that a harness will work from anything '92-'95, but again, I don't know for sure. It would take some probing with a multimeter to find out for sure if all the pins match up. The 4.6 harness from the mustang isn't what you want. If you are really good at soldering and wiring, you could probably get any harness and just cut lengths of wire out of it to repair the harness in your truck.
