Ignition switch problems
Thread Starter
|
Elder User
Joined: Aug 2003
Posts: 568
Likes: 1
From: Kansas
Ignition switch problems
If I don't get my truck fully into "Park", I can't turn the ignition switch far enough to get the key out. It indicates that it is in "Park", but just raise the shift lever a little bit and there is no hang-up what so ever. Is there an adjustment anywhere to fix this problem? This is on my 03.
Senior User
Joined: Dec 2003
Posts: 266
Likes: 0
From: Albuquerque NM
Trakman, what you could do is first block the truck so it does not move and get under the drivers side and pop off the shift linkage cable from the shift lever on the tranny and then get inside the truck and run the shift through the gears and then put back into park and see if the key comes out freely. If it does then your shift cable needs to be adjusted and if not then the shifter is hanging up inside the column.
