I am installing my Ididit Steering Column.....Seems that my Sanderson Headers are in the way....Running this by you Gurus to see if this will fly. I cut my metal steering shaft linkage and slid it up the column about 3 inches to simulate a longer column. I will drill a hole in the linkage and put a bolt through the column and the shaft. Then I will take a Joint and connect it to the other half of the metal linkage connected to the Rack. Do you people think this will sufice or do I need a Bearing Support. In my opinon I dont think so being that I am extending the column so to Speak......Thanks for taking the time to read this.....

Thanks
Patrick

P.S. Will call IDIDIT n morn to see if shoving the double D shaft in column is OK