how to?
Thread Starter
|
New User
Joined: Dec 2003
Posts: 13
Likes: 0
how to?
Just wondering, I have autometer oil and temp guages ina pillar pod. Oil's ok, but both temp guages read low with the autometer sending unit. If you don't connect the stock guage wiring, the check guage light stays on. Anyone know how to fool the stock guage into reading normal without affecting the autometer guage? Maybe a resistor in line or something? I'm scratching my head on this one.
Moderator
Joined: Jan 2004
Posts: 13,851
Likes: 111
From: SW Va
Are you trying to run both guages off the same sensor at the same time???
If so, why not consider installing a "T" fitting in the block & putting each guage on it's own correct sending unit, that way everyone is happy.
If so, why not consider installing a "T" fitting in the block & putting each guage on it's own correct sending unit, that way everyone is happy.
