Bottom Dooor Channels
Thread Starter
|
Junior User
Joined: Jun 2004
Posts: 86
Likes: 0
From: Troy, Kansas
Bottom Dooor Channels
Door bottom channels I figure I'm just going to make some but any bodt got any seggestion. These are the channels that hold the door seal away from the drain holes. I have about every catalog known to Ford truck restoration and have never seen any.
5th Wheeling
Joined: Mar 2003
Posts: 40
Likes: 1
From: Kansas City
I fabricated mine. I took a piece of 1 inch sqare tubing, and cut it down the middle. this gave me 2 "C" shaped sections. I then cut them down more so that the lip off of the "C" was mush shorter. I did some grinding on the ends as they had all most no "C" shape to them. After that both ends were bent slightly (as were the originals) to allow standoff in the middle. Finally 5 holes were drilled for the mount. It was very easy to do and I did both in about 2 hours. try to get the square tubing with walls as thin as the originals (18 or 19 guage).
Bulldog58
Bulldog58
