Holley projection return line?
Thread Starter
|
Senior User
Joined: Aug 2002
Posts: 184
Likes: 0
From: Chattanooga US
Holley projection return line?
Where am I going to run this return line that has to be installed?
I'm sure someone has dealt with this in the past.
'69 ranger 390 A/T ps,pdb,tilt,ac(working on that one now)
It's the pro-jection 670 cfm.
Thanks
Greg
I'm sure someone has dealt with this in the past.
'69 ranger 390 A/T ps,pdb,tilt,ac(working on that one now)
It's the pro-jection 670 cfm.
Thanks
Greg
Junior User
Joined: Jul 2001
Posts: 91
Likes: 0
From: Magnolia, Delaware
I soldered a return line into my sending unit on my 1967 when I swapped it to 5.0 Mustang SEFI. I used 5/16 bendable brakeline and with a tubing bender it came out nice. I put a union at the sending unit so that I could remove the sending unit easily.
