removing hydraulic line from slave-Please help
Thread Starter
|
New User
Joined: Apr 2004
Posts: 4
Likes: 0
removing hydraulic line from slave-Please help
Hey everyone,
I am in the process of changing my clutch on an 88 Bronco II, Mitsu FM146 tranny. I busted up the plastic quick release bushing on the outside of the bell housing, so its not so quick anymore, now is not really working. Can i release the line from inside the bell housing, there is a small hole above the hydraulic line connection for a 1.75 mm allen wrench mabye(seems like an allen wrench hole, but 1.5 too small, 2 too big)? Please give me some help if you have encountered this bc this is the last thing that is preventing me from taking the tranny off my floor jack. Thanks alot.
I am in the process of changing my clutch on an 88 Bronco II, Mitsu FM146 tranny. I busted up the plastic quick release bushing on the outside of the bell housing, so its not so quick anymore, now is not really working. Can i release the line from inside the bell housing, there is a small hole above the hydraulic line connection for a 1.75 mm allen wrench mabye(seems like an allen wrench hole, but 1.5 too small, 2 too big)? Please give me some help if you have encountered this bc this is the last thing that is preventing me from taking the tranny off my floor jack. Thanks alot.
Last edited by chrisn156; Apr 27, 2004 at 05:04 PM.
New User
Joined: Mar 2004
Posts: 2
Likes: 0
From: St.Hog,Fla.
It's been a couple of yrs but I believe that little hole has a retainer pin, If you push in a little on the plastic line and push into the hole with a snug fitting allen wrench the pin will release the hyd line, be careful not to loose the pin, it's real tiny...
