Will this transfer case bolt up? Please help
Thread Starter
|
New User
Joined: Nov 2003
Posts: 19
Likes: 0
Will this transfer case bolt up? Please help
I have an 89 bronco with a bw1356 transfer case, it has the yokes on the front and rear that bolt up to the driveshafts. I am swapping in a manual shift bw1356, I'm sick of the automatic transfer case. The manual transfer case I found is out of a 93, where it bolts up to the rear driveshaft it doesn't have a yoke, it is just a circle plate where it can bolt up. Can I swap that yoke piece off of the automatic transfer case onto the manual one? Please help, thanks for your time.
Senior User
Joined: Aug 2000
Posts: 473
Likes: 1
From: Richmond, CA
I am pretty sure that there wouldn't be problem with swapping out that round plate and then mounting your origanal yokes to match your drive shafts. One thought, how about putting in an Atlas II Transfer case, instead of the B/W 1356 transfer case. I just installed one in my rig three weeks ago. I now have twin sticks, one stick for each drive shaft, instead of the single shifter. Also, my rig runs so much smoother than before.
Hope this helps
Hope this helps
Senior User
Joined: Jan 2003
Posts: 142
Likes: 0
From: Oklahoma
Not sure about yoke swap. Pretty easy to trial fit if you already have the tranfer case. If they won't swap, the driveline shop should be able to change double cardan joint to fit up to yoke. That's what I did on mine. I figured it was due for some new u- joints anyway. Ron
