steering column swap?
Thread Starter
|
Senior User
Joined: Sep 2002
Posts: 126
Likes: 0
From: staunton
steering column swap?
I have a 89 F250 4X4, with CC but no tilt wheel, I found a 87 F? steering column with CC and tilt just like I want but it is out of a 2WD truck will this fit? and does it have to come out of a F250 to fit in my truck or are the F-series the same.. Thanks
Post Fiend
Joined: Nov 2000
Posts: 6,060
Likes: 7
From: Glendale Arizona
Just replaced last week a 87 bronco tilt with an 89 F250 tilt..direct swap. Unbolt the slide extension steering shaft off of yours (single bole where the shaft leaves the firewall) and put it on the new one in place of the 2 wheel drive one.
About a 30 minute swap.
Beware of the tilts tho as they have weak slide mechinisims for the key and ignition rod. check this out before spending the cash for the 89..
Garbz
About a 30 minute swap.
Beware of the tilts tho as they have weak slide mechinisims for the key and ignition rod. check this out before spending the cash for the 89..
Garbz
