Power Window Question
Thread Starter
|
Cross-Country
Joined: Mar 2003
Posts: 95
Likes: 0
Power Window Question
Hey all
I noticed on my 97 and this new truck today that when I wind the powerwindows up they slip outside the rubebr moulding on the side by the pillar (leading to the passenegr door) then slips back into the moulding when it reaches the top. Anyone seen this issue ?
It got really bad on my 97 where I literally had to pull the window back into the moulding.
One last question how do you go about programming speed sensitive locks for example start driving or put it in drive and teh vehicle locks the doors ?
Thanks
WC
I noticed on my 97 and this new truck today that when I wind the powerwindows up they slip outside the rubebr moulding on the side by the pillar (leading to the passenegr door) then slips back into the moulding when it reaches the top. Anyone seen this issue ?
It got really bad on my 97 where I literally had to pull the window back into the moulding.
One last question how do you go about programming speed sensitive locks for example start driving or put it in drive and teh vehicle locks the doors ?
Thanks
WC
