extension housing
Thread Starter
|
Cargo Master
Joined: Oct 2003
Posts: 2,833
Likes: 5
From: Jefferson, Iowa
extension housing
I was finally able to locate an extension housing from jeffs bronco graveyard. I got it for 96 dollars. My old extension housing on my 78 F-100 has a borken ear on it, so the entire transmission twists. What is all involved in changing this. To me it looks like it disconnect it from the tranny, disconnect the transfercase linkage, take the bolt out of the remaining ear which bolts to the mount, then pull the transfercase and extension housing, the drivshaft should come off. Now is where it extends beyond my knowledge. Is there fluid of anysort traveling in the extension housing? Do i need any gaskets? Do i just pull it off and change it, or is it not that simple?
Last edited by 78fordman; Dec 14, 2003 at 08:59 PM.
Posting Guru
Joined: Dec 2002
Posts: 1,113
Likes: 0
From: Remsen, NY
I don't know for 100% sure on all. I do know that the extension housing (tailshaft) is filled with the same oil as in the transmission and it should just unbolt and bolt on, sliding over the output shaft. Parts store like NAPA would know about a gasket if there was one.
What kind of transmission is it?
Bump for someone who knows more...
What kind of transmission is it?
Bump for someone who knows more...
