Transfer case
Thread Starter
|
5th Wheeling
Joined: Oct 2025
Posts: 44
Likes: 2
Transfer case
So I learned the 92-97 f-series had two different transfer cases (should’ve known that from the start lol) to my knowledge it’s the 1356 and 4407
now my question is which was more commonly used on the 94.5-97 f350 powerstrokes with the e4od? From I can find it seems to be the 4407 with the flange yoke and not the slip yoke to the rear axle (at least according to rockauto when I open a power stroke f350’s driveshaft section) can someone tell me a bit more? Im curious
now my question is which was more commonly used on the 94.5-97 f350 powerstrokes with the e4od? From I can find it seems to be the 4407 with the flange yoke and not the slip yoke to the rear axle (at least according to rockauto when I open a power stroke f350’s driveshaft section) can someone tell me a bit more? Im curious
Last edited by ArticTheWolf; Nov 3, 2025 at 08:58 AM.
SPONSOR
Joined: Jan 2025
Posts: 499
Likes: 306
From: White Bear Lake
The 4407 was 96 and 97HD only 8501gvwr and above. Light duty 5.8 trucks still used the 1356. The 1356 was in everything else all the way back to 87.
-Dan F
-Dan F
Thread Starter
|
5th Wheeling
Joined: Oct 2025
Posts: 44
Likes: 2
so basically all 96-97 powerstrokes (f-250HD and f-350) had the 4407 with the flange yoke? Good to know thanks
Thread
Thread Starter
Forum
Replies
Last Post
made4mud357
Clutch, Transmission, Differential, Axle & Transfer Case
2
Mar 14, 2008 07:05 PM
rxfx101
Clutch, Transmission, Differential, Axle & Transfer Case
2
May 14, 2005 11:46 AM
jaimalade
Clutch, Transmission, Differential, Axle & Transfer Case
4
Jun 5, 2003 11:22 AM
