Crank no start
Thread Starter
|
Mountain Pass
Joined: Sep 2016
Posts: 229
Likes: 0
Crank no start
I’m gonna try to cover everything of done from the start till now. I’m the second mechanic to mess with it went in for a mechanical lift pump, was replaced but crank no start. Had a bunch of codes when I started on it, I’m down to cyl 4 injector circuit low (p02270) and high side open bank 1 (p1293). Injector buzz test seems to work only for left bank (right bank completely dead) I’ve ohm tested the injector feeds back to the idm and there’s no breaks in the wires and they aren’t grounded out. New valve cover harness and pigtails for both sides. I swapped in a known good idm for the same result. Fuel bowl fills when cranking. Icp was leaking oil through the sensor body so it got replaced. I even tried the harness wiggle test but it didn’t make a difference
Lead Driver
Joined: Apr 2016
Posts: 7,222
Likes: 1,343
From: Bahstun
https://www.ford-trucks.com/forums/1...load-test.html
Maybe you missed a wire if both IDM says a short. Use above to ohm out and do a load test if needed.
Maybe you missed a wire if both IDM says a short. Use above to ohm out and do a load test if needed.
Thread
Thread Starter
Forum
Replies
Last Post
DumpsterJooce
1999 - 2003 7.3L Power Stroke Diesel
9
Jun 12, 2024 12:44 PM
Hector370zT
1999 - 2003 7.3L Power Stroke Diesel
20
Apr 11, 2022 07:58 PM
npccpartsman
6.0L Power Stroke Diesel
15
Aug 27, 2009 12:04 AM
