2000 7.3l Engine Rebuild.
#256
The following users liked this post:
#257
The following users liked this post:
#258
The following users liked this post:
#259
#260
#261
Hi everyone, here’s an update !
this is the part I was dreading the most and for good reason! It’s hard putting one of these big 7.3s in the van chassis! Not something I want to do again !
everything went well for the most part. I dinged up the corners of my valves covers. Managed to remove it without damaging the valves covers though… weird
Also had an issue getting the transmission to line up. Could not get the torque converter bolts to line up with the flex plate! And I would adjust it a little bit and it would be on the opposite side of the hole! Had to do that 3 or 4 times before it finally lined up and set into place.
motor mounts are secured, transmission is secured.
Time to have a beer!
this is the part I was dreading the most and for good reason! It’s hard putting one of these big 7.3s in the van chassis! Not something I want to do again !
everything went well for the most part. I dinged up the corners of my valves covers. Managed to remove it without damaging the valves covers though… weird
Also had an issue getting the transmission to line up. Could not get the torque converter bolts to line up with the flex plate! And I would adjust it a little bit and it would be on the opposite side of the hole! Had to do that 3 or 4 times before it finally lined up and set into place.
motor mounts are secured, transmission is secured.
Time to have a beer!
The following 7 users liked this post by LegalizeChey:
#262
The following users liked this post:
#263
The following users liked this post:
#264
Thread
Thread Starter
Forum
Replies
Last Post
hockeyhockey
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
3
11-01-2022 01:50 PM
Finger__Rachet
1987 - 1996 F150 & Larger F-Series Trucks
93
03-19-2015 01:42 PM