oxegen sensor wiring harness
Thread Starter
|
New User
Joined: Oct 2003
Posts: 8
Likes: 0
From: New York
oxegen sensor wiring harness
Would anyone know the size of the wiring harness for the oxegen sensor on a 1993 3.0 rear wheel drive. It has dual catalitic converters, some kind of heat exchanger thing, then the muffler. Or maybe tell me where to find the size. Thanks
Last edited by buffalobill; Nov 19, 2003 at 07:29 AM.
Elder User
Joined: Dec 2002
Posts: 624
Likes: 0
From: Georgia
I'm not sure just what you are looking for. I haven't even touched my OxYgen sensor. However here is a link to the online Chilton's procedure to change one. Maybe this will help.
http://www.cybrrpartspro.com/Chilton...24CH04_19.HTML
http://www.cybrrpartspro.com/Chilton...24CH04_19.HTML
Senior User
Joined: Nov 2003
Posts: 148
Likes: 0
From: CANADA
02 sensor
When i changed mine on my 95 areostar I didnt know the length so I just got the longest one and just tied up the excess with a twist tie. Not too tight to screw up the wires though, just to hold them together. You should be able to get a rough idea of how long just by crawling under the van and look how far the plug and sensor are from each other.
